OPB：3-Jaw Large Through Hole High Speed Power Chuck,OPB-206、 OPB-208、 OPB-210、 OPB-212、 OPB-215、 OPB-218
1. A power chuck is suitable for installation on a lathe machine, milling machine, or special machine to clamp workpieces.
2. A chuck with an open center through-hole allows the workpiece to be inserted into the through-hole
3. By enlarging the through-hole, larger workpieces can be inserted.
4. A 3-jaw chuck is suitable for clamping round bar workpieces, while 2-jaw and 4-jaw chucks are suitable for clamping irregular workpieces.
5. The power chuck needs to be actuated by a hydraulic rotary cylinder and a draw-bar to achieve the clamping action.
$800.00 – $3,200.00
Compare
| Model | OPB-206, OPB-208, OPB-210, OPB-212, OPB-215, OPB-218 |
|---|
Based on 1 review
Add a review
Related products
-
CHANDOX
P-S：Large Through Hole Super Thin Hollow Rotary Hydraulic Cylinder
1.Super thin & Lightweight：Super thin outer structure makes the weight lighter than the traditional rotary cylinders； meanwhile, the compactness and miniaturization lower the burden of machines.
2.Large Thru-hole Diameter：With large open center, gripping range of Bar stock can be increased.
3.Built-in Check Valve：With built-in “check valve”, work pieces can be effectively prevented from flying out during abrupt failure of pressure.SKU: n/a -
CHANDOX
MEL,MELT：2、3-Jaw Crank Type Long Jaw Stroke Hollow Power Chuck Fixtures,MEL-06, MEL-08, MEL-10, MELT-06, MELT-08, MELT-10
CHANDOXMEL,MELT：2、3-Jaw Crank Type Long Jaw Stroke Hollow Power Chuck Fixtures,MEL-06, MEL-08, MEL-10, MELT-06, MELT-08, MELT-10
1. Crank Type Long Jaw Stroke with the large through-hole.
2. A super long jaw stroke chuck is suitable for clamping workpieces that need to avoid bulged parts.
3. Install on the hydraulic vertical stationary cylinder to connect the hydraulic pump to actuate the clamping work.SKU: n/a -
CHANDOX
OP：3-Jaw High Speed Hollow Power Chucks,OP-204、 OP-205、 OP-206、 OP-208、 OP-210、 OP-212、 OP-215、 OP-218、 OP-221
CHANDOXOP：3-Jaw High Speed Hollow Power Chucks,OP-204、 OP-205、 OP-206、 OP-208、 OP-210、 OP-212、 OP-215、 OP-218、 OP-221
1. A power chuck is suitable for installation on a lathe machine, milling machine, or special machine to clamp workpieces.
2. A chuck with an open center through-hole allows the workpiece to be inserted into the through-hole.
3. A 3-jaw chuck is suitable for clamping round bar workpieces, while 2-jaw and 3-jaw chucks are suitable for clamping irregular workpieces.
4. The power chuck needs to be actuated by a hydraulic rotary cylinder and a draw-bar to achieve the clamping action.SKU: n/a
zy2025 –
very good
zy2025 –